Honda CRF450L 2019 User Manual

Fuel Tank
48 Servicing Your Honda
Fuel Tank
Refer to Important Safety Precautions on page 33.
Removal
1. Remove the seat (page 46).
2. Remove the shroud A bolt (1), shroud B bolt
(2) and shroud C bolt (3).
3. Slide the shroud (4) toward the up to separate
them from the side cover (5), and then remove
the shroud.
The right and left shrouds can be removed in the
same manner.
4. Release the breather tube (6) from the tube
guide (7) on the top shelter (8).
5. Disconnect the breather tube (6) at the tube
joint (9).
6. Remove the fuel tank bolts (10) and washers
(11).
7. Lift the fuel tank (12) out of the frame to the
left of the frame.
Do not support the fuel tank by the fuel feed hose
(13).
NOTICE
The fuel tank is made of titanium material. Since
the fuel tank has not been painted, it might be
discolored with mud and dust.
To remove mud or dust, use a sponge or soft cloth
and a stainless steel kitchen detergent, then rinse
well clean water.
After washing, rinse with plenty of water and dry
with a clean cloth.
(1) shroud A bolt
(2) shroud B bolt
(3) shroud C bolt
(4) shroud
(5) side cover
(4)
(5)
(2)
(1)
(3)
(6) breather tube (8) top shelter
(7) tube guide (9) tube joint
(10) fuel tank bolts (11) washers
(7)
(6)
(8)
(9)
(6)
(11)
(10)
(10)
(11)
WARNING
Gasoline is highly flammable and
explosive.
You can be burned or seriously injured
when handling fuel.
• Stop the engine and keep heat, sparks
and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
(12) fuel tank
(13) fuel feed hose
(12)
(13)

Honda CRF450L 2019 Specifications

General

Engine Type	449cc liquid-cooled single-cylinder four-stroke
Bore x Stroke	96.0mm x 62.1mm
Compression Ratio	12.0:1
Fuel System	Programmed Fuel Injection (PGM-FI), 46mm throttle body
Transmission	6-speed
Rear Brake	Single 240mm disc
Front Tire	80/100-21
Rear Tire	120/80-18
Rake (Caster Angle)	28.5°
Wheelbase	58.9 inches
Seat Height	37.1 inches
Fuel Capacity	2.0 gallons
Ignition	Full transistorized ignition
Ground Clearance	12.4 inches
Front Suspension	49mm inverted fork; 12.0 inches of travel
Rear Suspension	Pro-Link Showa single shock, adjustable spring preload, compression and rebound damping
Front Brake	Single 260mm disc
Curb Weight	289 pounds
Valve Train	Unicam four-valve
Final Drive	Chain
Trail	4.6 inches (118mm)