Honda HRN216VKA User Manual

11-17
HRN216 HANDLEBAR/ CABLES/CONTROLS
4. FLYWHEEL BRAKE CABLE
PKA/VKA/VLA TYPES ONLY
REMOVAL/INSTALLATION
1. Cut the two cable ties that secure the flywheel brake cable to the handlebar.
2. Hold the 6 mm locking nut in place with a wrench, and then fully loosen the 6 x 45 mm flange bolt to remove the
flywheel brake cable assembly from the handlebar assembly. Be sure to turn the bolt and not the nut when
removing.
3. Remove the flywheel brake cable Z-fitting from the blade control lever.
4. Pinch the flywheel brake cable lock with needle-nose pliers and remove the cable lock from the flywheel brake
cable bracket.
5. Slide the inner cable through the cable holder slot.
6. Remove the flywheel brake cable Z-fitting from the flywheel brake arm.
7. Install the flywheel brake cable in the reverse order of removal.
8. Install new cable ties as shown for the appropriate type beginning on page 2-21
.
9. Start the engine and confirm flywheel brake operation.
6 mm NYLON
LOCKING NUT
FLYWHEEL
BRAKE
CABLE
6 x 45 mm FLANGE BOLT
Z-FITTING
FLYWHEEL
BRAKE ARM
CABLE LOCK
CABLE LOCK
SLOT
FLYWHEEL
BRAKE
CABLE
HANDLEBAR
FLYWHEEL
BRAKE
CABLE
Z-FITTING

Honda HRN216VKA Specifications

General

Brand	Honda
Model	HRN216VKA
Category	Lawn Mower
Language	English