Configuring PTZ Settings
37
Zoom: Click to zoom out the video image, or click to zoom in the video image.
Pan Speed: Select a speed (-5 to 5) from the dropdown list.
Tilt Speed: Select a speed (-5 to 5) from the dropdown list.
Zoom Speed: Select a speed (-5 to 5) from the dropdown list.
Focus Speed: Select a speed (-5 to 5) from the dropdown list.
Go to: Select a preset location from the drop-down list, and the camera will move to the
selected position. You should set a preset location first. See Preset and Patrol Settings on
page 39.
Home Location Settings
SET CURRENT POSITION AS HOME: Click to set the current position as the home location.
RESTORE HOME POSITION TO DEFAULT: Click to restore the home position to default.
Patrol List
This patrol list displays the configured patrols. Note that only one patrol can be applied at a
time. To enable/disable an existing patrol, click ON/OFF.
Click ADD A RECORDED PATROL or ADD A PRESET PATROL below to create a recorded
patrol or a preset patrol.
Figure 5-2 Patrol List
Adding A Recorded Patrol
The recorded patrol allows you to record the process moving along interested points
(positions) in your surveillance area while the camera memorizes every Pan/Tilt/Zoom/Focus
commands you gave in the process. You can then save the process as a recorded patrol. Due
to the limitation on system memory, you can configure 4 recorded patrols, each with a length
of 2 minutes.
To Next Page
Loading...
Need help?
General
