Honeywell 60 Series IP Camera Software Configuration Guide
62
Figure 7-6 Trigger Sources
Video motion detection
This option makes use of the built-in motion detection mechanism as a trigger source. To
enable this function, you need to configure a Motion Detection Window first. For more
information, see Configuring Motion Detection Settings on page 57.
Periodically
This option allows the camera to trigger periodically for every other defined minute. Up to 999
minutes can be set.
Alarm input
This option allows the Network Camera to use an external digital input device or sensor as a
trigger source. Depending on your application, there are many choices of digital input devices
on the market which helps to detect changes in temperature, vibration, sound, and light, etc.
System boot
This option triggers the camera when the power to the camera is disconnected and re-
connected.
Recording notification
This option allows the camera to trigger when the recording disk is full or when recording
starts to overwrite older data.
Camera tampering detection
This option allows the camera to trigger when the camera detects that is being tampered with.
To enable this function, you need to configure the Tampering Detection option first, see
Configuring Tampering Detection Settings on page 58.
Action
It defines the actions to be performed by the camera when a trigger is activated.
To Next Page
Loading...
Need help?
General
