Configuring Network Settings
55
After the certificate file is uploaded successfully, if you want to remove the certificate, click
REMOVE.
Upload files
Go to Setup Network Setup HTTPS Upload files.
You can import the certificate from third party here.
Figure 6-14 Upload files
To import the certificate from third party:
1. In the Certificate field, click CHOOSE FILE to select a certificate file you have already
applied from 3rd party or CA domain.
2. In the Key field, click CHOOSE FILE to select a certificate key you have already applied
from 3rd party or CA domain.
3. Click UPLOAD and reboot camera.
After the certificate file is uploaded successfully, if you want to remove the certificate, click
REMOVE.
Note
• Supported certificate type: HTTPS protocol.
• Supported certificate file format: *.cert format.
• Supported Key format: PEM format.
Configuring IEEE 802.1X Settings
Go to Setup Network Setup 802.1X.
IEEE802.1X is the access control and authentication protocol for local and metropolitan area
networks. It uses a port-based network access control protocol to restrict unauthorized user
and/or device access to the LAN. The network devices, intermediary switch/access point/hub,
and RADIUS server must support and enable 802.1x settings.
To configure IEEE 802.1x settings:
1. Before connecting the camera to the protected network with 802.1x, apply a digital
certificate from a Certificate Authority (i.e., your network administrator) which can be
validated by a RADIUS server.
2. Connect the camera to a PC or notebook outside of the protected LAN. Open the
configuration page of the camera as shown below.
To Next Page
Loading...
Need help?
General
