Configuring PTZ Settings
41
• Auto: Select this mode and the camera will auto focus all the time, except the presets with
fixed focus. This mode is applicable to most scenarios.
• One-time focus: Select this mode and the camera will auto focus once after the PTZ
control is stopped.
• Spotlight avoidance: Select this mode and the camera will perform the focus in
accordance with the spot light environment at night.
• Manual: Select this mode to manually adjust the focus.
Enable digital zoom: Select the checkbox and you will be able to zoom in on an image by up
to 360X magnification with the combination of the 30x mechanical zoom and another 12X
digital zoom.
Zoom factor display: Select the checkbox to display zoom factor on the video image.
Apply previous action if the camera idles for 5 seconds: From the dropdown list, select an
action to be taken when the camera sits idle for a configurable period time. For example, you
can let camera resume a patrol tour. The resumed patrol will continue from the last preset
position. You may also let the camera return to the home position. The idle state does not
include the situations when the camera is performing pan or patrol action.
• Enable auto tracking: Select it and the camera will perform auto tracking. It will return
home position before auto tracking.
• Return to home position: Select it and the camera will return to home position.
• Start to pan: Select it and the camera will start to pan.
• Start to patrol: Select it and the camera will start to patrol.
Calibrate
Go to Setup PTZ Setup Calibrate.
This function re-calibrates the home position to the default center to recover any
displacement caused by external forces. Please note that there is no confirm message after
using the function, and the calibration immediately takes place. If, after a long use, a user
finds it is difficult to move camera’s field of view to a specific point, use this function to
restore the camera’s original coordinates in pan and tilt motions.
To Next Page
Loading...
Need help?
General
