PAGE - 16 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
Through the arrow keys select the item which is required to be changed (“Check “ or “Check Enabl.”)
through pressure of the enter key the editing function is activated.
Through the arrow keys data are entered and through the enter key
entered data are confirmed.
VERIFY ENABLE: selecting “YES” the verification Function is ACTIVE with the programmed verification Time (
in seconds)
SILENCE TAB
SELF-SILENCING TIME is the time after which the output modules are reset, after being activated.
Press the right Arrow key to change the parameters to manage the Silencing:
NOTE: the self-silencing function of each output module must be enabled in the Point Programming .
Silence Inhibit time is the time that output modules will remain active without the ability to be Silenced by an
operator.
By pressing the enter key
the editing function is activated.
Through the arrows keys data are entered and through the enter key
entered data are confirmed.
FAULTS signalings timings TAB
Press the right Arrow key to change the parameters to manage the Fault signallings: :
MAINS FAULT DETECTION TIME is the minimum time during which Mains Fault is signalled if there is
no mains
Through the arrow keys select the item which is required to be changed (“Mains”, “Tx Faults” ) by
pressing the enter key
the editing function is activated
Through the arrow keys data are entered and through the enter key
entered data are confirmed.
Mains Loss
Timings are expressed in
seconds, from a minimum of
0 sec. to a max. of 300 sec.
Siren / HORN Type-ID outputs
Silence Inhibition:
Time after activation when is not possible
to Silence
Silence Autom:
Minimum activation time
Silence Autom.Enabl:
Enabling of use the Activation time
( otherways outputs are active until
Reset)
All timings are expressed in seconds,
from a minimum of 0 sec. to a max. of
255 sec.
To Next Page
Loading...
Need help?
General
