PAGE - 4 Programming Manual AM_8200
NOTIFIER ITALIA Doc. M-162.1-AM8200-ENG Rev A2 AM8200_manu-prog-ENG
F
F
R
R
O
O
N
N
T
T
P
P
A
A
N
N
E
E
L
L
C
C
O
O
N
N
T
T
R
R
O
O
L
L
S
S
A
A
N
N
D
D
S
S
I
I
G
G
N
N
A
A
L
L
L
L
I
I
N
N
G
G
S
S
K
K
e
e
y
y
s
s
w
w
i
i
t
t
h
h
d
d
e
e
d
d
i
i
c
c
a
a
t
t
e
e
d
d
f
f
u
u
n
n
c
c
t
t
i
i
o
o
n
n
s
s
EVACUATION: Command for activating the Siren output and all output modules programmed with Type SW = SND in the
absence of alarms and faults.
To do this you need to know the level 2 password.
DELAY RESET:
This button is active only in case of alarm if the immediate activation of the Sounder outputs in the exclusions menu has
been excluded.
The panel delays the activation of the above-mentioned outputs for the programmed times ( Prog\ Sist\ Al. Output Timing ).
During the delay time the Active Delay led flashes and it is possible to reset the current delay through the Delay Reset key.
SILENCE BUZZER:
by pressing this key, the operator can silence the Panel buzzer and is enabled to perform a RESET.
SOUNDER ON/OFF SILENCE:
This operation must be done with level 2 password..
In case of alarm the following devices are activated:
Sounder Output
Output modules programmed with SW-Type-ID=SND
the output modules activated for a CBE associations
By pressing this key, you can de-activate the following devices:
Siren Output
Output modules programmed through Type-ID SND and enabled for silencing
All output modules activated through CBE associations and enabled for silencing
A subsequent pressure of this key will re-activate :
Siren Output
Output modules programmed through Type-ID SND
All the output modules de-activated from the previous Silencing
RESET:
This operation must be done with level 2 password
the pressure of this key clear alarms and faults from memory.
It de-activates the sounder and turns off all light signalling of sensors in alarm.
FUNCTION KEYS in LCD TOUCH SCREEN:
These keys are displayed in the bottom part of the LCD screen.
Activate the corresponding functions.
These functions change according to the selected menus.
Example: in the system status display, these keys allow the access to the
Programming, Utilities, Exclusion menus or the Test menu.
Keys to use: DURING THE PROGRAMMING or TO ENTER THE PASSWORDS
ARROWS: they are used to perform some selections.
NOTE: pressing and holding one of these keys for more than 1 second, you obtain the key automatic
repetition
.
ENTER: after performing a selection, it confirms the entered datum.
ESCAPE: “Back”, this is the menu exit function
To Next Page
Loading...
Need help?
General
