EXCEL 500/600 - INSTALLATION INSTRUCTIONS
EN1R-1047GE51 R0913 4
SAFETY INSTRUCTIONS
— When performing any work (installation, mounting, start-
up), all instructions given by the manufacturer and in
particular the safety instructions provided in the
Installation Instructions are to be observed.
— The Excel 500/600 controller may be installed and
mounted only by authorized and trained personnel.
— If the unit is modified in any way, except by the
manufacturer, all warranties concerning operation and
safety are invalidated.
— Make sure that certain local standards and regulations
are observed at all times. Examples of such regulations
are VDE 0800 and VDE 0100.
— Use only accessory equipment which comes from or has
been approved by Honeywell.
CAUTION
Risk of electric shock! Disconnect the power supply
before you start to install the Excel 500/600 Controller
and do not reconnect the power supply until you have
completed installation. NOTE: More than one
disconnect switch may be required to de-energize the
device.
ATTENTION
Risque de choc électrique. Il peut être nécessaire de
couper l'alimentation à plus d'un interrupteur pour
effectuer le désamorçage de ce dispositif.
CAUTION
Disconnect the power supply before plugging in or
removing the XDL505 Application Module.
To Next Page
Loading...
Need help?
General
