HP 16500C Programmer's Guide

STOP
Command :STOP
The STOP command stops the selected module (or Intermodule). If the
specified module is in the Intermodule configuration, then the Intermodule
run will be stopped.
The STOP command is an overlapped command. An overlapped command is a
command that allows execution of subsequent commands while the device
operations initiated by the overlapped command are still in progress.
Example OUTPUT XXX;":STOP"
Mainframe Commands
STOP
10–25

HP 16500C Specifications

General

Brand	HP
Model	16500C
Category	Measuring Instruments
Language	English