To Next Page

To Previous Page

STORe [:CONFig]

Command :MMEMory:STORe[:CONfig] <name>[,<msus>],

<description>[,<module>]

The STORe command stores configurations onto a disk. The [:CONFig]

specifier is optional and has no effect on the command. The <name>

parameter specifies the file on the disk. The <description> parameter

describes the contents of the file. The optional <module> parameter allows

you to store the configuration for either the system or the modules. If the

optional <module> parameter is not specified, the configurations for the

system, modules, and any installed software options are stored.

<name> A string of up to 10 alphanumeric characters for LIF in the following form:

NNNNNNNNNN

A string of up to 64 alphanumeric characters for DOS in one of the following

forms:

NNNNNNNN.NNN when the file resides in the current directory or

\NAME_DIR\FILENAME when it does not reside in the current directory

<msus> Mass Storage Unit specifier. INTernal0 for the hard disk drive and

INTernal1 for the flexible disk drive.

<description> A string of up to 32 alphanumeric characters

<module> An integer, –2 through 5 for the HP 16500C alone. –2 through 10 with an

HP 16501A connected.

Example OUTPUT XXX;":MMEM:STOR ’DEFAULTS’,’SETUPS FOR ALL MODULES’"

OUTPUT XXX;":MMEMORY:STORE:CONFIG ’STATEDATA’,INTERNAL0,

’ANALYZER 1 CONFIG’,1"

The appropriate module designator "_X" is added to all files when they are

stored. "_X" refers to either an __ (double underscore) for the system or an _(A

through E) for an HP 16500C alone or an _(A through J) with an HP 16501A

connected.

MMEMory Subsystem

STORe [:CONFig]

12–23

HP 16500C Programmer's Guide

Other manuals for HP 16500C