To Next Page

To Previous Page

AUToload

Command :MMEMory:AUToload {{OFF|0}|{<auto_file>}}[,<msus>]

The AUToload command controls the autoload feature which designates a set

of configuration files to be loaded automatically the next time the instrument

is turned on. The OFF parameter (or 0) disables the autoload feature. A

string parameter may be specified instead to represent the desired autoload

file. If the file is on the current drive, the autoload feature is enabled to the

specified file. The configuration files specified must reside in the root

directory of the current drive.

<auto_file> A string of up to 10 alphanumeric characters for LIF in the following form:

NNNNNNNNNN

A string of up to 12 alphanumeric characters for DOS in the following form:

NNNNNNNN.NNN

<msus> Mass Storage Unit specifier. INTernal0 for the hard disk drive and

INTernal1 for the flexible disk drive.

Example Disabling autoload:

OUTPUT XXX;":MMEMORY:AUTOLOAD OFF"

Setting FILE2 on the hard drive as the autoload file:

OUTPUT XXX;":MMEMORY:AUTOLOAD ’FILE2 ’,INTERNAL0"

Query :MMEMory:AUToload?

The AUToload query returns 0 if the autoload feature is disabled. If the

autoload feature is enabled, the query returns a string parameter that

specifies the current autoload file.

Returned Format

[:MMEMory:AUToload] {0|<auto_file>},<msus><NL>

Example OUTPUT XXX;":MMEMORY:AUTOLOAD?"

MMEMory Subsystem

AUToload

12–7

HP 16500C Programmer's Guide

Other manuals for HP 16500C