The Stop/Single Key
Pressing the Stop/Single key causes the instrument to stop acquiring data.
The status area of the screen displays the message:
Acquisition is stopped.
Each subsequent press of the Stop/Single key rearms the trigger circuit. A
complete acquisition cycle is performed, any measurements are recalculated,
and the status area of the screen displays the message:
Acquisition
is
complete.
If all
of the
channels are
turned o
or
if
a
trigger
event
is
not
found,
the
instrument will
not acquire
any data.
2-8
To Next Page
Loading...
Need help?
General
