HP GbE2c - Blc Layer 2/3 Fiber SFP Option Application Guide

Accessing the switch 13
User configuration
Users can be configured to use the authentication/privacy options. The GbE2c supports two authentication
algorithms: MD5 and SHA, as specified in the following command:
/cfg/sys/ssnmp/snmpv3/usm <x>/auth md5|sha
1. To configure a user with name 'admin,' authentication type MD5, and authentication password of 'admin,'
privacy option DES with privacy password of 'admin,' use the following CLI commands:
>> # /cfg/sys/ssnmp/snmpv3/usm 5
>> SNMPv3 usmUser 5 # name "admin" (Configure ‘admin’ user type)
>> SNMPv3 usmUser 5 # auth md5
>> SNMPv3 usmUser 5 # authpw admin
>> SNMPv3 usmUser 5 # priv des
>> SNMPv3 usmUser 5 # privpw admin
2. Configure a user access group, along with the views the group may access. Use the access table to configure
the group’s access level.
>> # /cfg/sys/ssnmp/snmpv3/access 5
>> SNMPv3 vacmAccess 5 # name "admingrp" (Configure an access group)
>> SNMPv3 vacmAccess 5 # level authPriv
>> SNMPv3 vacmAccess 5 # rview "iso"
>> SNMPv3 vacmAccess 5 # wview "iso"
>> SNMPv3 vacmAccess 5 # nview "iso"
Because the read view (rview), write view (wview), and notify view (nview) are all set to “iso,” the user type has
access to all private and public MIBs.
3. Assign the user to the user group. Use the group table to link the user to a particular access group.
>> # /cfg/sys/ssnmp/snmpv3/group 5
>> SNMPv3 vacmSecurityToGroup 5 # uname admin
>> SNMPv3 vacmSecurityToGroup 5 # gname admingrp
If you want to allow user access only to certain MIBs, see the “View based configurations” section.

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English