Server Specific Troubleshooting
Table D-7: SmartStart Fails During Installation
Possible Cause Possible Solution
An operating system has not been selected.
1. Press the F9 key to run RBSU.
2. Select the primary operating system.
An error occurs during installation. Follow the error information provided. If
necessary, clear NVRAM in RBSU and reinstall
the operating system.
The CMOS is not cleared. Clear NVRAM in RBSU and reinstall the
operating system.
IMPORTANT: Clearing NVRAM removes user data from the boot drives. To clear NVRAM and
erase the boot drives, select the Advanced Options menu in RBSU, and then select Erase
NVRAM/Boot Space Disk.
Table D-8: Server Cannot Load the Operating System
Possible Cause Possible Solution
Required operating system step was missed. Follow these steps:
1. Note at which phase the operating system
failed.
2. Remove any loaded operating system.
3. Refer to the operating system
documentation.
4. Install the operating system again.
Installation problem occurred. Refer to the operating system documentation
and to the SmartStart Release Notes on the
SmartStart CD.
Run RBSU and check the OS Selection menu.
continued
HP ProLiant ML330 Generation 3 Server Setup and Installation Guide D-11
HP CONFIDENTIAL
Writer: Rob Weaver File Name: k-appd Server Specific Troubleshooting.doc
Codename: Flashback Part Number: 322383-001 Last Saved On: 2/11/03 1:35 PM
To Next Page
Loading...
Need help?
General