NonStop Pathway/iTS Management Programming Manual—426749-002
1-1
1 Introduction
This manual describes the management programming interface to the PATHMON
environment provided by Pathway/iTS. It describes how to use programmatic
commands in a management application to configure Pathway/iTS objects that support
transaction-processing requesters, how to monitor the status and performance of these
objects, and how to handle error and event messages returned by the Pathway
subsystem.
Which Sections Do You Need?
This manual is organized into logical groups of information for easy reference.
Table 1-1 is a descriptive map indicating which sections are relevant to particular
operating environments.
Note. This manual describes the objects created and controlled by the Pathway/iTS product to
support requesters in a Pathway environment. Objects created and controlled by the TS/MP
product, which support servers in a Pathway environment, are described in a separate manual
set. For more information about those objects, see the TS/MP Management Programming
Manual.
Table 1-1. Configuration and Manual Correspondences
If Your Configuration
Includes… You Need… To Perform the Following…
SPI management
interface
Section 2
Section 3
Sections 4-6
Sections 11-
12
Section 13
Section 14
Learn how to do management programming
Learn Pathway/iTS-specific programming
information
Look up definitions of command and response
tokens
Look up event and error messages
See management programming examples
See error-handling examples
Internal TCPs Section 7
Section 10
Section 11
Section 12
Define and control TCPs
Control messages from TCPs to terminals
Handle event messages from TCPs
Handle error messages from TCPs
Terminals Section 8 Define and control configured TERM objects;
control and obtain information about
temporary TERM objects
Templates for terminals
running other than
SCREEN COBOL
programs
Section 9 Define and control PROGRAM objects
To Next Page
Loading...
Need help?
General