EasyManuals Logo
Home>HP>Software>NonStop Pathway/iTS

HP NonStop Pathway/iTS User Manual

HP NonStop Pathway/iTS
694 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #584 background imageLoading...
Page #584 background image
TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-14
Error-Message Range 3000 Through 3999
Recovery. Informational message only; no corrective action is needed.
3052: ZPWY-ERR-TCP-STOPBYPROG
The TERM object stopped because it encountered an exit in the highest-level program
unit.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. None.
Recovery. Informational message only; no corrective action is needed.
3053: ZPWY-ERR-TCP-BADNUMERICNODD
An operation that does not involve screen presentation, such as an ADD or MOVE
operation, attempted to perform a numeric operation using nonnumeric data.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. Isolate and correct the problem within the SCREEN COBOL program. For
instructions on how to locate the problem within the program, see Additional
Information for Terminal Errors on page 12-3.
3054: ZPWY-ERR-TCP-IOPROTOCOLDENIED
The I/O protocol is invalid. The value of the ZIOPROTOCOL field in
ZPWY-DDL-DEF-TERM was 1, but the front-end process does not support completion
of outstanding READ requests as specified in the TCP’s call to the Guardian
CONTROL procedure.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The operation fails.
Recovery. Use the ALTER TERM command to specify a valid value for the
ZIOPROTOCOL field. The ZINFO field of the STATUS TERM display shows the reply
code received from the TCP’s initial call to the CONTROL procedure.
3055: ZPWY-ERR-TCP-BADIOPROTOCOL
The I/O protocol specified in the terminal configuration is invalid. A value other than 0
or 1 was specified for the ZIOPROTOCOL field in ZPWY-DDL-DEF-TERM. PATHMON
reports this error if the invalid value is greater than 15; otherwise, PATHCOM reports
error 2011, ILLEGAL NUMBER.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP NonStop Pathway/iTS and is the answer not in the manual?

HP NonStop Pathway/iTS Specifications

General IconGeneral
BrandHP
ModelNonStop Pathway/iTS
CategorySoftware
LanguageEnglish

Related product manuals