HP NonStop Pathway/iTS User Manual

PROG Commands
NonStop Pathway/iTS Management Programming Manual—426749-002
9-8
ALTER PROGTERM
ALTER PROGTERM
Use the ALTER PROGTERM command to change the attributes that define a given
device type supported by a PROG object.
Continuation
You cannot use continuation with this command to alter more than one PROGTERM
object; you must alter each PROGTERM separately.
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-36. For descriptions of tokens and fields, see
Section 4 through Section 6.
Considerations
•
To perform the equivalent of the PATHCOM ALTER PROGRAM, RESET TYPE
command, use the DELETE PROGTERM command.
•
If you have added the maximum number of PROG entries supported by the
PATHMON process (that is, 4095) and issue an ALTER PROGTERM command,
the command fails with the following error:
*1108* TOO MANY PROGRAM ENTRIES
The command fails because the PATHMON process executes the ALTER
PROGTERM command by creating a new PROG entry with the altered values
before deleting the existing PROG entry. When the maximum number of PROG
entries already exists, the PATHMON process does not have the space to create a
Command
ZPWY-CMD-ALTER
Object Type
ZPWY-OBJ-PROGTERM
Tokens in Command Buffer
ZPWY-MAP-SEL-PROGTERM token-type ZPWY-DDL-SEL-PROGTERM. !r
ZPWY-MAP-DEF-PROGTERM token-type ZPWY-DDL-DEF-PROGTERM. !r
Tokens in Response Buffer
ZPWY-MAP-SEL-PROGTERM token-type ZPWY-DDL-SEL-PROGTERM.

HP NonStop Pathway/iTS Specifications

General

Brand	HP
Model	NonStop Pathway/iTS
Category	Software
Language	English