TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-55
Error-Message Range 3000 Through 3999
3240: ZPWY-ERR-TCP-MAXINPUTMSGS
The value specified for the ZMAXINPUTMSGS field in ZPWY-DDL-DEF-TCP
exceeded 2045. This is a TCP internal error.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The TCP terminates.
3241: ZPWY-ERR-TCP-UNSOLREJECTED
The TCP rejected an unsolicited message for the reason specified in the returned error
number. This message is generated for either the TCP or an individual terminal.
Effect. The TCP rejects the unsolicited message and replies to the sender without
delivering it to the target requester.
Recovery. Recovery depends on the type of the error that occurred. errnum can be
one of the following:
For information about unsolicited-message errors, see the Pathway/iTS TCP and
Terminal Programming Guide.
0 No error.
1 A file-system error occurred.
2 Target terminal is suspended.
3 Target terminal queue is full. (The TERM MAXINPUTMSGS configuration value
has been exceeded.)
4 Target TCP queue area is full.
5 Target queueing is not enabled. (The TCP MAXINPUTMSGS configuration
value is set to 0.)
6 Length field in the message exceeds the configured maximum for the TCP.
7 There was an unrecognizable request code (refers to MSG-ID and
MSG-VERSION fields).
8 Named terminal is not found.
9 MAXINPUTMSGS value has been exceeded.
1
0
RECEIVE UNSOLICITED MESSAGE error occurred. INFO1 provides the
reason, which is the value obtained from the TERMINATION-STATUS register.
1
1
The number of bytes in the reply message sent by the SCREEN COBOL
requester exceeded the number of bytes supported by the sender of the
unsolicited message. This is a warning and should occur only during the
application-debugging phase.
To Next Page
Loading...
Need help?
General