TCP Error Messages
NonStop Pathway/iTS Management Programming Manual—426749-002
12-24
Error-Message Range 3000 Through 3999
Recovery. Contact your service provider.
3106: ZPWY-ERR-TCP-CONFIGTOOBIG
The TCP configuration parameters are incorrect. This is usually caused by
incompatible values for two of the following fields in ZPWY-DDL-DEF-TCP:
ZTERMBUF, ZTERMPOOL, ZMAXTERMDATA, ZSERVERPOOL, and ZMAXREPLY.
This may also be caused by incompatible values for two of the following fields in
ZPWY-DDL-DEF-PATHWAY: ZMAXTERMS, ZMAXSERVERCLASSES, and
ZMAXSERVERPROCESSES.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The TCP terminates.
Recovery. Use the ALTER TCP command to correct the configuration values.
3107: ZPWY-ERR-TCP-SWAPCREATE
A file-system error occurred while the specified TCP was attempting to obtain swap
space from the Kernel Managed Swap Facility (KMSF).
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The swap space is not obtained from the KMSF.
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.
3108: ZPWY-ERR-TCP-SWAPOPEN
A file-system error occurred while the specified TCP was opening a swap file.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The swap file is not opened.
Recovery. For information regarding the specified file-system error, see the Guardian
Procedure Errors and Messages Manual.
3109: ZPWY-ERR-TCP-SWAPIO
A file-system error occurred during an I/O operation to a swap file.
This error does not appear in the RETCODE token or in an error list; it appears only in
response to a STATUS TCP or STATUS TERM command.
Effect. The I/O operation fails.
To Next Page
Loading...
Need help?
General