HP ProLiant ML370 User Manual

Removal and Replacement Procedures
Removing the Server from the Rack
You need to remove the server from the rack when performing non-hot-plug removal and
replacement procedures. To remove the server from the rack:
1. Power down the server. Refer to “Powering Down the Server” in this chapter.
2. Disconnect all AC power cords from the AC outlets and then from the server.
Figure 2-5: Unlocking the cable management arm hinge
Figure 2-6: Swinging open the cable management arm to access
the cables
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-9

HP ProLiant ML370 Specifications

General

Brand	HP
Model	ProLiant ML370
Category	Server
Language	English