HP ProLiant ML370 User Manual

Removal and Replacement Procedures
To replace the system board and all components connected to it, reverse steps 4 through 11.
NOTE: Be sure that you align the six retaining guides on the chassis with the holes on the system
board when replacing it.
Processor Cage Assembly
To remove the processor cage assembly:
1. Power down and remove power from the server. Refer to “Powering Down the Server” in
this chapter.
2. Unlock the front bezel (tower server only).
3. Remove the access panel. Refer to “Access Panel” in this chapter.
4. Remove the processor air baffle. Refer to “Processor Air Baffle” in this chapter.
5. Remove the expansion boards. Refer to “PCI-X Expansion Boards” in this chapter.
6. Remove the center wall. Refer to “Center Wall” in this chapter.
7. Disconnect all cables.
8. Remove the system board. Refer to “System Board” in this chapter.
9. Remove the processor. Refer to “Processor Assembly” in this chapter.
10. Remove the PPM. Refer to “Processor Power Module” in this chapter.
11. Remove all DIMMs. Refer to “Removing DIMMs” in this chapter.
12. Remove the six processor cage screws using the Torx T-15 tool.
NOTE: The Torx T-15 tool is clipped to the rear panel of the server to the right of the right-most fan
grating.
Figure 2-53: Removing the processor cage screws
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-57

HP ProLiant ML370 Specifications

General

Form Factor	Tower
Server Type	Tower Server
Chipset	Intel C600 Series Chipset
Maximum Memory	384 GB
Network Controller	HP Ethernet 1Gb 2-port 330i Adapter or HP FlexibleLOM
Drive Bays	Up to 24 SFF or 18 LFF
Management	HP iLO (Integrated Lights-Out)
Storage Controller	Smart Array