LED Indicators and Switches
System Configuration Settings
It may be necessary at some time to clear and reset system configuration settings. When the
system maintenance switch position 6 is set to the on position, the system is prepared to erase
all system configuration settings from both CMOS and NVRAM. For additional information
about locating the switch and switch settings, refer to “System Maintenance Switch” in this
chapter. The default setting for all positions is off.
IMPORTANT: Clearing CMOS and/or NVRAM deletes your configuration information. Refer to the HP
ProLiant ML370 Generation 3 Server Setup and Installation Guide for complete instructions on
configuring the server.
IMPORTANT: You must re-enter the server serial number through RBSU after you clear NVRAM.
Refer to “Re-entering the Server Serial Number” in Chapter 2.
To erase all system configuration settings:
1. Power down the server.
2. Open the front bezel (tower only).
3. Remove the access panel.
4. Remove the processor air baffle.
5. Set the position 6 lever to the on position.
6. Power up the server. All configuration settings are now erased and all system operations
halt.
7. Power down the server.
8. Reset the position 6 lever to the default off position.
9. Power up the server.
10. Press the F9 key to run RBSU and reset all system configuration settings.
NOTE: For instructions on using RBSU to reset system configuration settings, refer to the HP
ProLiant ML370 Generation 3 Server Setup and Installation Guide or the HP ROM-Based Setup
Utility User Guide.
4-18 HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
To Next Page
Loading...
Need help?
General