Details and SolutionDescriptionEvent code
Check the version of firmware used for the
upgrade. The firmware is incompatible with
this device.
SCSI: flash image does not fit bootcode44
The application software has locked media
removal and either the software or device
user interface attempted to remove the media.
NOTE:
This IS NOT a hardware issue.
If the issue cannot be resolved with the
application software, power off the device,
disconnect the data cable, and then power
on the device.
SCSI: media removal prevented by drive45
SCSI: media removal prevented by library46
Check the firmware file used for the upgrade.
The firmware is incompatible with this device.
SCSI: flash image does not fit personality47
The tape drive is not supported by the
firmware in this device. Upgrade the device
firmware to the most up-to-date version. Verify
that the drive has an HP MSL-G3 or 1/8 G2
firmware revision. If firmware is not the
correct type, the wrong tape drive has been
installed. Use only HP-approved support to
insure that the correct tape drives are used.
SCSI: tape drive not supported by this library48
Verify that a supported magazine for that slot
is inserted. If the magazine is in the lower left
position, verify that the type of magazine is
consistent with the mailslot configuration.
SCSI: incompatible magazine, magazine not
accessible
49
• Retry the operation.
• Check the status of extended Libraries.
Source not ready4A
• Retry the operation.
• Check the status of extended Libraries.
Destination not ready4B
The application software made an illegal
request.
Reservation failed4C
Retry the operation.
Library controller busy4D
Invalid robotic request4E
Robotic not initialized4F
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
guide 207
To Next Page
Loading...
Need help?
General
