9
Use this transceiver to connect the switch directly to a single mode fiber-optic cable or to multi-mode fiber
using a conditioned launch cable.
To activate the SFP port:
1. Hold the transceiver so that the fiber connector is toward you and the product label is visible, as shown
in Figure 51.Ensure the wire release lever is closed (in the upright position).
Figure 51 Inserting an SFP Transceiver
2. Gently slide the transceiver into the SFP slot until it clicks into place.
CAUTION:
SFP transceivers are keyed and can be properly inserted only one way. If the transceiver does not click
hen you insert it, remove it, turn it over, and reinsert it.
3. Remove the plastic protective cover, if fitted.
4. Connect the fiber cable.
5. Attach a male duplex LC connector on the network cable into the duplex LC connector on the
transceiver.
6. Connect the other end of the cable to a device fitted with an appropriate Gigabit Ethernet connection.
7. Check the Module Active LEDs on the front of the switch to ensure that the SFP transceiver is operating
correctly.
Removing an SFP Transceiver
To remove an SFP transceiver:
1. Disconnect the cable from the transceiver.
2. Move the wire release lever downwards until it is pointing toward you.
3. Pull the wire release lever toward you to release the catch mechanism.
The SFP transceiver should slide out easily.
To Next Page
Loading...
Need help?
General
