Initial workstation configuration and deployment
The workstation includes a preinstalled system software image. After a brief software unbundling
process, the workstation is ready to use.
If you prefer to replace the preinstalled software image with a customized set of system and application
software, several methods are available for deploying a customized software image, including:
ā
Installing additional software applications after unbundling the preinstalled software image
ā
Using a disk cloning process to copy the contents from one hard disk drive to another
The Restore Plus! CD, ROM-based setup, and ACPI hardware provide further assistance with recovery
of system software, configuration management and troubleshooting, and power management.
Support for specific features described in this guide can vary by model and software version.
The best deployment method depends on the information technology environment and processes.
Installing a remote system
Remote system installation enables starting and setting up the workstation using software and
configuration information on a network server. This feature provides a useful system setup and
configuration tool for the following tasks:
ā
Deploying a software image on new PCs
ā
Formatting a hard disk drive
ā
Installing application software or drivers
ā
Updating the operating system, application software, or drivers
To initiate a remote system installation, press F12 when F12=Network Service Boot appears in the
lower right corner of the HP logo screen. Follow the onscreen instructions to continue the installation
process. The default boot order is a BIOS configuration setting that can be changed to always attempt
a PXE boot.
44 Chapter 4 System management ENWW
To Next Page
Loading...
Need help?
General
Weight and Dimensions
