Step 9 Connect the cable of the supercapacitor to the RAID controller card. See Figure
5-70.
Figure 5-70 Connecting the supercapacitor cable
Step 10 Install the chassis cover. For details, see 5.8 Chassis Cover.
Step 11 Install the server. For details, see 5.4.3 Installing the Server on Guide Rails.
Step 12 Connect the power cables. For details, see 5.7 PSU.
Step 13 Power on the server. For details, see 5.4.1 Powering On the Server.
Step 14 Log in to the iBMC WebUI, and check whether the new component is normal. For
details, see the
TaiShan Rack Server iBMC User Guide
.
----End
5.16 DIMM
Removing a DIMM
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power
o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Remove the air duct. For details, see 5.9 Air Duct.
Step 7 Simultaneously press the ejectors outwards. See (1) in Figure 5-71.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 132
To Next Page
Loading...
Need help?
General