1
CONTROLS AND EQUIPMENT
55
Sidelight auto cut (Not all models)
o The purpose of this feature is to
prevent the battery from being dis-
charged. The system automatically
turns off the small light when the
driver removes the ignition key and
opens the driver- side door.
o With this feature, the sidelight will be
turned off automatically if the driver
parks on the side of road at night.
If necessary, to keep the lights on when
the ignition key is removed, perform the
following :
1) Open the driver-side door.
2) Turn the sidelights OFF and ON
again using the light switch on the
steering column.
SB220E1-E
Headlight Flash
The headlights may be flashed by pull-
ing the turn signal switch lever towards
the steering wheel. The headlights will
be extinguished when the switch is
released.
SB220D1-E
High And Low Beam
To turn on the headlight high beams,
push the lever forward (away from you).
For low beams, pull the lever back
(toward you). The appropriate headlight
beam indicator light will come on at the
same time.
B340E01FC-D
WINDSCREEN WIPER/
WASHER SWITCH
SB230A1-E
The windscreen wiper switch, depen-
dent upon model, has three operating
positions.
1.Intermittent wiper operation
(Not all models)
2.Low speed operation
3.High speed operation
NOTE:
To prevent damage to the wiper sys-
tem, do not attempt to wipe away
heavy accumulations of snow or ice.
Accumulated snow and ice should
be removed manually. If there is only
a light layer of snow or ice, operate
the heater in the defrost mode to melt
the snow or ice before using the
wiper.
B350A01FC-D
(1)
(2)
(3)
fcuk-1.p65 12/27/2006, 10:12 AM55
To Next Page
Loading...
Need help?
General
