2
DRIVING YOUR HYUNDAI
5
STARTING
SC060A1-E
Starting The Petrol Engine
C050A01E
1. Ensure that the transaxle is in neu-
tral and that the clutch pedal is held
depressed (manual transaxle) or the
transaxle selector is at the "P" posi-
tion (automatic transaxle vehicle).
2. Turn the ignition key to and hold at
the "Start" position until the engine
starts. When the engine has started,
release the key.
NOTE:
Do not operate the starter for more
than 15 seconds continuously or
continue to operate the starter after
the engine has started to avoid dam-
aging the starter motor. If the engine
makes a false start, allow it and the
starter motor to come to rest before
attempting to start the engine again.
Never attempt to start the engine with
the transaxle in gear.
Do not depress the accelerator pedal
whilst starting the engine. Allow the
engine to idle for 20 seconds or so
before driving the vehicle.
CAUTION:
Do not leave the vehicle unattended
whilst idling. Never allow the vehicle
to idle or warm up in a confined
space (ie garage) longer than is nec-
essary to move the vehicle into an
open area.
!
SC090D1-F
To Remove the Ignition Key
C070C01E
1. Turn the ignition key to the "ACC"
position.
2. Simultaneously push and turn the
ignition key counterclockwise from
the "ACC" position to the "LOCK"
position.
3. The key can be removed in the
"LOCK" position.
LOCK
ACC
ON
START
fcuk-2.p65 12/27/2006, 10:14 AM5
To Next Page
Loading...
Need help?
General
