2
DRIVING YOUR HYUNDAI
4
!
KEY POSITIONS
SB050B1-E
STEERING WHEEL LOCK
When the key is removed, the steering
column lock will be activated and will
engage when the steering wheel is turned
to the appropriate position. It is not
necessary to turn the wheel until locked
each time the key is removed since in
the event of any unauthorised attempt
at removal, the lock will become effec-
tive as soon as the steering wheel is
turned. To unlock the steering, insert
the key and turn to the "ACC" position.
If the steering is locked, it may be
necessary to rock the steering wheel
slightly to facilitate turning the key.
Under no circumstances should the
key be forced since breakage of the key
will occur.
NOTE:
Do not hold the key in the "START"
position for more than 15 seconds.
o "ON"
When the key is at the "ON" position,
the ignition and all accessories are
available for use.
If the engine is not running, the key
should not be left at this position since
the battery will become discharged and
damage to the ignition system may
also result. For information regarding
engine starting, refer to "STARTING
THE ENGINE".
o "ACC"
When the ignition key is at the "ACC"
position, the radio and other accesso-
ries may be used.
o "LOCK"
The ignition key may only be inserted or
removed at this position.
SC050A2-E
C040A01E
LOCK
ACC
ON
START
WARNING:
The engine must never be turned off
and the key removed from the igni-
tion key cylinder whilst the vehicle is
in motion since the steering lock will
operate and control of the vehicle
will be lost.
o "START"
The engine is started in this position. It
will crank until you release the key.
fcuk-2.p65 12/27/2006, 10:14 AM4
To Next Page
Loading...
Need help?
General
