1
CONTROLS AND EQUIPMENT
70
FOLD-UP TRAY
B570A01FC-EAT
Pull the release lever inside the vehicle
to unlatch the bonnet. At the front of the
vehicle, push the safety catch lever
sidewards as shown and raise the bon-
net by hand. Support the bonnet by
means of the bonnet prop.
Before closing the bonnet, ensure that
the prop is correctly stowed. Lower the
bonnet by hand to a position of approxi-
mately 30cm from the closed position
and allow the bonnet to drop. Do not
attempt to close the bonnet by lowering
the panel to the closed position and
pressing upon the panel work since this
may result in damage to the panel.
BONNET RELEASE
HIGH-MOUNTED REAR STOP
LIGHT
B550A01S-EAT
In addition to the lower-mounted rear
stoplights on either side of the car, the
high mounted rear stoplight in the cen-
tre of the rear window or inserted in the
rear spoiler also lights when the brakes
are applied.
B550A02FC
B810A01FC-GAT
For your convenience, it may be used
as a table holding a book, cup or can.
!
WARNING:
To avoid the possibility of injury in
case of an accident or a sudden stop,
the fold-up tray should be place its
original position whilst the vehicle
is moving.
HFC2070
HFC2018-D
fcuk-1.p65 12/27/2006, 10:12 AM70
To Next Page
Loading...
Need help?
General
