201
Replacement Procedures and Illustrated Parts List
Installation
ATTENTION
To prevent electrostatic damage to electronic components, wear a
properly grounded static wrist strap when handling circuit boards, the
shuttle frame assembly, and any other electronic component.
NOTE: When flash SIMMs are removed from one controller board and
placed on another controller board, the SIMMs must be placed on
the new board in the same order and location as on the original
board.
1. Install the DRAM SIMM, Flash Memory, and Security PAL on the
controller board (page 224).
2. Position the controller board assembly in the card cage, shield side
down, component side up. Engage the screw on the bottom of the card
cage in the keyway in the controller shield. Slide the board to right until
the serial cable connector J201 on the board lines up with the cutout in
the card cage. (See page 275, Figure 45.)
3. Tighten the screw securing the controller shield near serial cable
connector J201.
4. Tighten the screw securing the controller shield to the bottom of the card
cage.
5. Connect all cable connectors to the controller board, using the
Interconnection diagram on page 295 as your guide.
6. Cabinet Model: Install the paper guide assembly (page 235).
Pedestal Model: Install the top cover assembly (page 210).
IMPORTANT
If the original CMX board was replaced, you must download the
emulation software again. Installing flash memory from the old board
onto the new board does not transfer all operating system software.
7. Load flash memory (page 181).
8. Models –014 and –015 only: adjust the coil temperature if the original
CMX board was replaced (page 188).
9. Models –004, –04P, –005, and –05P only: set shuttle speed if the original
CMX board was replaced (page 189).
To Next Page
Loading...
Need help?
General
