206
Replacement Procedures and Illustrated Parts List
Cover Assembly, Hammer Bank / Ribbon Mask
Removal
1. Prepare the printer for maintenance (page 194).
2. Remove the shuttle frame assembly (page 249).
3. Early models:
Lift the thick plate of the hammer bank cover assembly at one end, and
peel the cover away from hammer bank magnets. (See Figure 31, page
208.)
4. Later models:
a. Using a Torx T-10 driver, remove the six screws and three ribbon
mask clamp plates securing the ribbon mask to the hammer bank
cover. Remove the ribbon mask. (See Figure 31, page 208.)
NOTE: If you are replacing just the ribbon mask, simply loosen the six
screws until you can slip the ribbon mask off the alignment pins.
b. Using a Torx T-10 driver, remove the 12 screws securing the hammer
bank cover to the hammer bank. Remove the hammer bank cover.
(See Figure 31, page 208.)
To Next Page
Loading...
Need help?
General
