246
Replacement Procedures and Illustrated Parts List
Shaft, Splined
Removal
1. Prepare the printer for maintenance (page 194).
2. Open the printer cover.
3. Remove the paper supports from the splined shaft and support shaft.
(See Figure 48, page 281, item 21.)
4. Remove the paper feed timing belt (page 195).
5. Remove the ground clip (page 281, Figure 48).
6. With grip ring pliers, remove the grip ring from left side of the splined
shaft.
7. Pull the bearing and spring link with the spring off the left side of the
splined shaft.
8. Unlock the left and right tractors and slide them to the center of the shaft.
9. Remove the bearing clamp on the right side of the splined shaft.
10. Hold the tractors so they do not fall, grasp the vertical adjustment knob,
and slide the splined shaft to the right out of the side plates and the
tractors.
To Next Page
Loading...
Need help?
General
