248
Replacement Procedures and Illustrated Parts List
Shaft, Support
Removal
1. Prepare the printer for maintenance (page 194).
2. Open the printer cover.
3. Unlock the tractors and slide them to the far right.
4. Remove the paper supports from the splined shaft and support shaft.
(See Figure 48, page 281, item 21.)
5. Remove the E-ring (page 281, Figure 48).
ATTENTION
Hold the tractors while removing the support shaft, and be careful not
to lose the curved spring washers. (See Figure 48, page 281, item 5.)
6. Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer and
screw—to the left, out of the tractors and the left side plate.
Installation
1. Slide the support shaft assembly—consisting of the support shaft, two
curved washers, bushing, horizontal adjustment knob, washer, and
screw—into the left side plate. (See page 281, Figure 48.)
2. Slide the tractors onto the support shaft.
3. Slide the support shaft assembly through the right side plate.
4. While pushing on the knob to compress the curved washers, install the
E-ring in the groove on the bushing.
5. Install the paper supports on the splined shaft and support shaft. (See
Figure 48, page 281, item 21.)
6. Return the printer to normal operation (page 159).
To Next Page
Loading...
Need help?
General
