256
Replacement Procedures and Illustrated Parts List
Switch Assembly, Platen Interlock
Removal
1. Prepare the printer for maintenance (page 194).
2. Cabinet Model: Remove the paper guide assembly (page 235).
Pedestal Model: Remove the top cover assembly (page 210).
3. Fully close the forms thickness lever (position ‘A’).
4. Trace the platen interlock switch cable back to the controller board.
Remove tie-wraps as necessary to free the cable. (See cable routing
diagram on page 306.)
5. Disconnect connector shell P107 (P7) from the controller board.
6. Remove the platen interlock cable connector from the connector shell
(page 198).
7. Remove two screws securing the platen interlock switch assembly. (See
Figure 49, page 283.)
8. Remove the platen interlock switch assembly from the switch bracket.
9. Remove the switch cable from the cutout in the right side plate.
To Next Page
Loading...
Need help?
General
