255
Replacement Procedures and Illustrated Parts List
Installation
1. Holding the slotted wheel against the PMD sensor, position the paper
detector switch assembly and install the screws securing it to the printer
base. (See Figure 50, page 285.)
2. Check the PMD sensor arm range: make sure it travels freely and
completely back into the sensing cavity.
3. Route switch cables PMD and POD back to the controller board,
installing the cables in the restraints under the base casting. (See cable
routing diagram on page 306.)
4. Connect switch cables PMD and POD to the connector P106 (page 198),
then connect P106 to controller board connector J106.
5. Cabinet Model: Install the barrier shield and tighten the four screws.
(See page 269, Figure 43, items 3, 4, and 9.)
Pedestal Model: Install the paper guide, barrier shield, and four screws.
(See page 271, Figure 44, items 3, 4, and 5.)
6. Cabinet Model: Install the paper guide assembly (page 235).
Pedestal Model: Install the top cover assembly (page 210).
7. Check and adjust the End of Forms Distance (page 175).
8. Return the printer to normal operation (page 159).
To Next Page
Loading...
Need help?
General
