209
Replacement Procedures and Illustrated Parts List
Cover Assembly, Shuttle
Removal
1. Prepare the printer for maintenance (page 194).
2. Open the printer cover.
3. Remove the ribbon spools.
4. Loosen the shuttle cover screws (page 269, Figure 43).
5. Grasping the edges of the shuttle cover assembly, tilt up the rear edge
and lift the shuttle cover assembly out of the printer.
Installation
1. Place the shuttle cover assembly in the printer. Tilt the forward edge of
the cover down slightly and work the cover into position (page 269,
Figure 43).
NOTE: Make sure the holes in the cover are over the locating pins.
2. Tighten the shuttle cover screws (page 269, Figure 43).
3. Return the printer to normal operation (page 159).
To Next Page
Loading...
Need help?
General
