RECover n
You substitute the number of lines you want to recover for
"n."
The recovered line(s) will appear immediately above the
current line. You can put the lines back where they belong
by using the m prefix command, discussed later.
Duplicating Lines
If
you want to repeat a line in a file, you can use the
II
(double quotation mark) prefix command.
If
you want the
line duplicated more than one time, type a number before
or
after the ".
Copying Lines
If
you want to copy lines from one part
of
a file to another,
you can use the c prefix command.
To copy one line, type a letter c in the prefix area of the line
you want to copy.
Then
you have to tell the editor where
you want it to be copied. You do this by typing either an
f
(for "following")
or
a p (for "preceding") in the prefix area
of
another line. When you press ENTER, a copy
of
the line
where you typed the
"c"
is
placed:
• Either after the line containing an
"f"
Or
before a line containing a
"p."
For
example:
====c
This
is
the
line
I want
copied.
====f want
it
to
be
copied
after
this
line.
When the
ENTER
key is pressed, file will look like this:
Chapter 5.
Using
VM/PC
Commands to Do Work
5-17
To Next Page
Need help?
General
