IBM UPS3000 LV User Manual

Contents
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii
Chapter 1. Introduction . . . . . . . . . . . . . . . . . . . . . .1
The IBM Documentation CD . . . . . . . . . . . . . . . . . . . .1
Hardware and software requirements . . . . . . . . . . . . . . . .1
Using the Documentation Browser . . . . . . . . . . . . . . . . .2
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . .3
Notices and statements in this document . . . . . . . . . . . . . . . .4
Chapter 2. Installing the uninterruptible power supply in a rack or tower
configuration . . . . . . . . . . . . . . . . . . . . . . . . .5
Inventory checklist . . . . . . . . . . . . . . . . . . . . . . . .5
Rack configuration . . . . . . . . . . . . . . . . . . . . . . . .5
Tower configuration . . . . . . . . . . . . . . . . . . . . . . . .6
Setting up the uninterruptible power supply (with no extended battery module) 7
Setting up the uninterruptible power supply with an extended battery module 8
Setting up the uninterruptible power supply with two or more extended battery
modules . . . . . . . . . . . . . . . . . . . . . . . . . .9
Connecting the internal battery . . . . . . . . . . . . . . . . . . .10
Connecting the uninterruptible power supply to the extended battery modules
(rack configuration) . . . . . . . . . . . . . . . . . . . . . .11
Connecting the uninterruptible power supply to the extended battery modules
(tower configuration) . . . . . . . . . . . . . . . . . . . . . .12
Completing the installation . . . . . . . . . . . . . . . . . . . . .13
Remote emergency power-off installation . . . . . . . . . . . . . . .14
Chapter 3. Uninterruptible power supply controls, LEDs, operating modes,
and power . . . . . . . . . . . . . . . . . . . . . . . . .17
Front view . . . . . . . . . . . . . . . . . . . . . . . . . .17
Rear view . . . . . . . . . . . . . . . . . . . . . . . . . . .18
Operating modes . . . . . . . . . . . . . . . . . . . . . . . .18
Normal mode . . . . . . . . . . . . . . . . . . . . . . . .19
Battery mode . . . . . . . . . . . . . . . . . . . . . . . .19
Bypass mode . . . . . . . . . . . . . . . . . . . . . . . .19
Standby mode . . . . . . . . . . . . . . . . . . . . . . . .19
Configuration mode . . . . . . . . . . . . . . . . . . . . . .20
Turning on the uninterruptible power supply . . . . . . . . . . . . . .22
Starting the uninterruptible power supply on battery . . . . . . . . . . .22
Turning off the uninterruptible power supply . . . . . . . . . . . . . .22
Load segments . . . . . . . . . . . . . . . . . . . . . . . . .22
Chapter 4. Using the Web/SNMP card . . . . . . . . . . . . . . . .25
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . .25
System application . . . . . . . . . . . . . . . . . . . . . . .26
Web/SNMP card LEDs and controls . . . . . . . . . . . . . . . . .27
Configuring the Web/SNMP card locally . . . . . . . . . . . . . . . .27
Before you begin . . . . . . . . . . . . . . . . . . . . . . .27
Connecting the card to a terminal or computer . . . . . . . . . . . .28
Configuring the Web/SNMP card . . . . . . . . . . . . . . . . .28
Set the IP address, gateway address, and MIB system group . . . . . . .29
Set Web/SNMP card control group . . . . . . . . . . . . . . . .30
Set write access managers . . . . . . . . . . . . . . . . . . .30
Set trap receivers . . . . . . . . . . . . . . . . . . . . . . .30
© Copyright IBM Corp. 2006 ix

IBM UPS3000 LV Specifications

General

Brand	IBM
Model	UPS3000 LV
Category	UPS
Language	English