Tower configuration
The following sections provide instructions for setting up the uninterruptible power
supply and optional extended battery modules in a tower configuration.
CAUTION:
or
>32 kg (70.5 lb)
or
32-55 kg (70.5-121.2 lb)
The weight of this part or unit is between 32 and 55 kg (70.5 and 121.2 lb). It
takes three persons to safely lift this part or unit. (C010)
Note: The uninterruptible power supply and extended battery modules must be
stabilized with pedestals or EBM brackets. The setup varies depending on the
number of chassis you are installing:
v For one chassis: Install two sets of pedestals (see “Setting up the
uninterruptible power supply (with no extended battery module)” on page 7).
v For two chassis: Install two pedestals on each chassis and two extended
battery module brackets (see “Setting up the uninterruptible power supply with an
extended battery module” on page 8).
v For three chassis: Install four extended battery module brackets (see “Setting
up the uninterruptible power supply with two or more extended battery modules”
on page 9
v For four chassis: Install six extended battery module brackets (see “Setting up
the uninterruptible power supply with two or more extended battery modules” on
page 9
v For five chassis: Install eight extended battery module brackets (see “Setting up
the uninterruptible power supply with two or more extended battery modules” on
page 9
6 UPS 3000 LV and UPS3000 HV: Installation and Maintenance Guide
To Next Page
Loading...
Need help?
General
