IBM x3200 M3 7327 User Manual

Removing a memory module
To remove a dual inline memory module (DIMM), complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 141.
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see “Removing the side cover” on page
145).
4. Locate the DIMM connector that contains the DIMM that is to be replaced (see
“System-board optional-devices connectors” on page 18 for DIMM slot
locations).
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
5. Carefully open the retaining clips on each end of the DIMM connector and
remove the DIMM.
6. If you are instructed to return the DIMM, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
168 System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide

IBM x3200 M3 7327 Specifications

General

Brand	IBM
Model	x3200 M3 7327
Category	Server
Language	English