Server controls, LEDs, and power
This section describes the controls, light-emitting diodes (LEDs), and connectors on
the front and rear of the server, and how to turn the server on and off. For the
location of the LEDs on the system board, see “System-board LEDs” on page 19.
Note: The illustrations in this document might differ slightly from your model.
Front view
The following illustration shows the 3.5-inch SAS/SATA hot-swap hard disk drive
model:
The following illustration shows the 3.5-inch SATA simple-swap hard disk drive
model:
Chapter 2. Introduction 9