IBM x3200 M3 7327 User Manual

a. When you are prompted to start the Configuration/Setup Utility program,
restart the server and press F1.
b. Select System Settings → Devices and I/O Ports.
c. Select Console Redirection Settings; then, make sure that the values are
set as follows:
v COM Port 1: Enable
v Remote Console: Enable
v Serial Port Sharing: Enable
v Serial Port Access Mode: Dedicated COM1 Settings
v Baud Rate: 115200
v Data Bits:8
v Parity: None Stop
v Bits:1
v Thermal Emulation: ANSI
v Active After Boot: Enable
v Flow Control: Hardware
d. Press Esc twice to exit the Devices and I/O Ports section of the
Configuration/Setup Utility program.
e. Select Save Settings; then, press Enter.
f. Press Enter to confirm.
g. Select Exit Setup; then, press Enter.
h. Make sure that Yes, exit the Setup Utility is selected; then, press Enter.
Using the LSI Configuration Utility program
Note: There are no RAID support on simple-swap models of the server.
Use the LSI Configuration Utility program to configure and manage redundant array
of independent disks (RAID) arrays on hot-swap models of the server. Be sure to
use this program as described in this document.
v Use the LSI Configuration Utility program to perform the following tasks:
– Perform a low-level format on a hard disk drive
– Create an array of hard disk drives with or without a hot-spare drive
– Set protocol parameters on hard disk drives
The integrated SAS/SATA controller with RAID capabilities supports RAID arrays.
The hot-swap server models come with the ServerRAID-BR10il adapter installed,
which provides RAID levels 0, 1, and 1E support. You can use the LSI
Configuration Utility program to configure RAID 1 (IM), RAID 1E (IME), and RAID 0
(IS) for a single pair of attached devices. If you install the optional
ServeRAID-MR10i SAS/SATA controller or the optional ServeRAID-MR10is VAULT
SAS/SATA controller with an encryption 1078 DE chip, they provide RAID levels 0,
1, 5, 6, and 10 support. If you install a different type of RAID adapter, follow the
instructions in the documentation that comes with the adapter to view or change
settings for attached devices.
In addition, you can download an LSI command-line configuration program from
http://www.ibm.com/systems/support/.
234 System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide

IBM x3200 M3 7327 Specifications

General

Brand	IBM
Model	x3200 M3 7327
Category	Server
Language	English