IBM x3200 M3 7327 User Manual

PCIe SAS slot
ServeRaid-BR10il
controller
3. Connect the signal cable to the SAS/SATA controller.
4. Install and lock the side cover (see “Installing the side cover” on page 146).
5. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing a non-hot-swap power supply
This procedure applies only to server models that have a non-hot-swap power
supply. See “Removing a hot-swap power supply” on page 165 for information
about the removal of a hot-swap power supply.
When you remove or install a non-hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
206 System x3200 M3 Types 7327 and 7328: Problem Determination and Service Guide

IBM x3200 M3 7327 Specifications

General

Brand	IBM
Model	x3200 M3 7327
Category	Server
Language	English