72
8 MEMORY/CALL CHANNELS
■ Memory clearing
Contents of programmed memories can be cleared (blanked),
if desired.
qPush and hold [MR/S.MW] for 1 sec. to enter select mem-
ory write mode.
• 1 short and 1 long beeps sound.
•“
µµ
” indicator blinks.
• Do not hold [MR/S.MW] for more than 2 sec. otherwise the
memory contents will be copied to VFO.
wRotate [DIAL] to select the desired memory channel to be
cleared.
ePush [2/SCAN](
∫∫
) or [8/TS](
√√
) to select “CLEAR.”
rPush and hold [MR S.MW] for 1 sec. to clear the contents.
• 3 beeps sound.
• The cleared channel changes to blank channel
• Return to select memory write mode.— “
µµ
” indicator blinks.
Push [VFO/MHz] to exit select memory write mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled even in bank channel operation.
To Next Page
Loading...
Need help?
General
