Icom IC-E90 Instruction Manual

56
8
SET MODE
■ Set mode items
Set mode is used for programming infrequently changed val-
ues or conditions of functions.
General set mode
R TONE Repeater tone (p. 57)
C TONE Tone squelch/pocket beep frequency (p. 57)
CODE DTCS squelch code (p. 57)
OFFSET Offset frequency (p. 57)
RESUME Scan resume time (p. 58)
PAUSE Scan pause timer (p. 58)
PRIO Priority watch (p. 58)
BEEP LV Beep tone level (p. 58)
BEEP Beep tone (p. 59)
LIGHT Display backlighting (p. 59)
BUSY Busy LED (p. 59)
AP OFF Auto power OFF (p. 59)
PSAVE Power save (p. 60)
MONI Monitor switch action (p. 60)
SPEED Dial speed acceleration (p. 60)
DTMF DTMF speed (p. 61)
MIC Optional HM-75A functions (p. 61)
EXP1 Expanded set mode 1 (upper right)
EXP2 Expanded set mode 2 (lower right)
EXP1 (Expanded set mode 1)
STOP B Scan stop beep (p. 62)
STOP L Scan stop LED (p. 62)
LIGHT P Backlighting position (p. 62)
COLOR Backlighting color (p. 63)
EDGE B Band edge beep (p. 63)
AP ON Auto power ON (p. 63)
LOCK Key lock effect (p. 63)
PTT LK PTT lock (p. 64)
CONT LCD contrast (p. 64)
OPN.MSG Opening message (p. 64)
Appears when expanded set mode 1 is ON.
EXP2 (Expanded set mode 2)
DTCS P DTCS phase mode (p. 65)
LK OUT Busy lockout (p. 65)
TOTTime-out timer (p. 65)
ACTIVE Active band (p. 65)
SPLIT Split operation (p. 66)
NARROW FM narrow deviation (p. 66)
MC SYN Morse code synthesizer (p. 66)
KY SPD Morse code keying speed (p. 66)
Appears when expanded set mode 2 is ON.
ii
SET MODE

Icom IC-E90 Specifications

General

Brand	Icom
Model	IC-E90
Category	Transceiver
Language	English