78
9
OTHER FUNCTIONS
■ Resetting
The function display may occasionally
display erroneous information (e.g.
when first applying power). This may be
caused externally by static electricity or
by other factors.
If this problem occurs, turn power OFF.
After waiting a few seconds, turn power
ON again. If the problem persists, per-
form either or both procedures below.
• All reset
Reset the CPU before operating the
transceiver for the first time, or when
the internal CPU malfunctions to clear
and return all programmed contents to
their default settings.
• Partial reset
If you want to initialize the operating
conditions (VFO frequency, VFO set-
tings, set mode contents) without clear-
ing the memory contents, a partial
resetting function is available for the
transceiver.
DAll reset
q Push [POWER] for 2 sec. to turn
power OFF.
w While pushing [BAND], [VFO] and
[MR], turn power ON to reset the
CPU.
• “CLEAR” appears when resetting the
CPU.
CAUTION: Resetting the CPU re-
turns all programmed contents to
their default settings.
DPartial reset
q Push [POWER] for 2 sec. to turn
power OFF.
w While pushing [VFO], turn power ON
to partially reset the transceiver.
• All resetting
To Next Page
Loading...
Need help?
General
