98 xGen Installation & Programming Guide
5. Enter the required details into your device/software. This will usual be your
xGen serial number, Web Access Passcode, and a valid Username and PIN
code. The xGen serial number can be found in the Device Info menu.
6. Verify the UltraConnect service is working by using your device/software to
connect your xGen system.
Troubleshooting
• Check the Web Access Passcode is correct. It cannot be 00000000.
• Check there is a valid user and they have a First name, this will be the login
name.
• Check the serial number is correct. It is printed on the xGen module.
• Check that the user permissions are currently valid.
• See Troubleshooting section in the Appendix for more information.
Programming Instructions for Event Lists
Goal
Create segmented lists of events so Channels can selectively deliver event
messages.
Pre-conditions
None.
Notes
If an event message is on an Event List then the Channel will attempt to deliver
it. If an event message is not on the Event List assigned to that Channel, it will
not attempt delivery even if the message has been sent to it.
Menu Overview
17. Event Lists
16
5. Channels
16
6. Communicator
17. Event Lists
To Next Page
Loading...
Need help?
General
