96 xGen Installation & Programming Guide
13. Select the channel group to send system events (e.g. low battery)
Next
• Perform tests on each of the communication paths to verify they are
functioning correctly.
• Program Channels.
• Program Channel Groups.
• Verify Number of Attempts, next channels (back-up channels), and multi-path
reporting function correctly.
Programming Instructions for UltraConnect
Pre-conditions
1. At least one user has been given a username and PIN code (see User
Programming).
2. xGen is connected to internet and has been allocated an IP address (see
Communicator Programming, IP Config).
Notes:
UltraConnect provides a secure VPN connection to your xGen over the internet.
You will need to provide your xGen serial number, Web Access Passcode, and a
valid Username and PIN code that exists in your xGen system. These codes
provide multiple levels of security for the connection.
The Web Access Passcode is needed for:
• web console over the internet via a secure VPN
• UltraConnect app
• DLX900 software connecting over IP, in addition to Download Access Code
The Web Access Passcode is NOT needed for:
• email services
• web console over a local LAN connection
Once UltraConnect is set up, you may connect to your xGen using the
UltraConnect app on your smartphone or tablet. This may require a separate
account and downloading additional software. See further instructions in the User
Manual.
To Next Page
Loading...
Need help?
General
